LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1806 (Engine - 5.4L (3V) - F-150 & Mark LT) >> In-Vehicle Servicing >> Oil Pan >> Installation >> 4WD vehicles

4WD vehicles

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Use care when positioning the front axle housing, or the vacuum lines to the axle solenoid may become disconnected or damaged.
  1. Position the front axle housing and loosely install the 3 bolts, aligning the bolt location marks made during removal.
  2. Install the front axle housing RH mounting bolt.
    • Tighten to 89 N.m (66 lb-ft).
    Fig 1: Locating Front Axle Housing RH Mounting Bolt
    GF0002774Courtesy of FORD MOTOR CO.
  3. Install the front axle housing LH front mounting bolt.
    • Tighten to 89 N.m (66 lb-ft).
    Fig 2: Installing Front Axle Housing LH Front Mounting Bolt
    GF0002775Courtesy of FORD MOTOR CO.
  4. Install the front axle housing LH rear mounting bolt.
    • Tighten to 89 N.m (66 lb-ft).
    Fig 3: Installing Front Axle Housing LH Rear Mounting Bolt
    GF0002776Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals