Engine Oil Pressure (EOP) Switch
WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
| Item | Part Number | Description |
|---|---|---|
| 1 | 14A464 | Engine oil pressure (EOP) electrical connector |
| 2 | 6C627 | EOP sensor |
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
- Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES article.
- Disconnect the engine oil pressure (EOP) sensor electrical connector.
- Remove the EOP sensor.
- To install, tighten to 21 N.m (15 lb-ft).
- To install, reverse the removal procedure.