LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1806 (Engine - 5.4L (3V) - F-150 & Mark LT) >> In-Vehicle Servicing >> Crankshaft Rear Seal >> Installation

Crankshaft Rear Seal: Installation

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Lubricate the crankshaft rear seal with clean engine oil prior to installation.
    Fig 1: Using Special Tools To Install New Crankshaft Rear Seal
    G04583928Courtesy of FORD MOTOR CO.
  1. Using the special tools, install a new crankshaft rear seal.
    2. NOTE: Lubricate the crankshaft oil slinger with clean engine oil prior to installation.
    Fig 2: Installing Crankshaft Rear Oil Slinger Using Special Tools
    G03920154Courtesy of FORD MOTOR CO.
  2. Using the special tools, install a new crankshaft oil slinger.
  3. Install the engine rear cover plate.
  4. Install the flexplate. For additional information, refer to Flexplate  in this article.
scientia non olet · About LEMON Manuals