LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1806 (Engine - 5.4L (3V) - F-150 & Mark LT) >> In-Vehicle Servicing >> Camshaft Roller Follower >> Removal

Camshaft Roller Follower: Removal

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Depending on the camshaft roller follower being serviced, remove the LH or RH valve cover. For additional information, refer to Valve Cover - LH  or Valve Cover - RH  in this article.
  2. Rotate the crankshaft until the piston for the valve being serviced is at the top of its stroke with the intake valve and the exhaust valves closed.
    3. CAUTION: If the components are to be reinstalled, they must be installed in the same positions. Mark the components for installation into their original locations.
    Fig 1: Identifying Special Tool For Removing/Installing Camshaft Roller Followers
    G03919946Courtesy of FORD MOTOR CO.
  3. Using the special tool, compress the valve spring and remove the camshaft roller follower.
  4. Repeat the previous 2 steps for each camshaft roller follower being serviced.
  5. Inspect the camshaft roller follower. For additional information, refer to ENGINE SYSTEM - GENERAL INFORMATION article.
scientia non olet · About LEMON Manuals