LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1803 (Driveline System - General Information -- F-150 & Mark LT) >> Diagnostic Tests >> Driveline System >> Inspection and Verification

Inspection and Verification

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify the customer concern.
  2. Visually inspect for obvious signs of mechanical damage.
    VISUAL INSPECTION CHART

    Mechanical
    • U-joints
    • Constant velocity (CV) joints
    • Center bearings
    • Driveshaft tubes
    • Mounting brackets
    • Flanges
    • Housing and cover damage
    • Differential bearings
    • Differential gear sets
    • Pinion bearings
     
  3. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
  4. If the cause is not visually evident, verify the symptom and Go to the Symptom Chart - Driveline or Go to Symptom Chart - Noise, Vibration and Harshness (NVH).