LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1800 (Rear Drive Axle/Differential - Ford 9.75-Inch Ring Gear -- F150 & Mark LT) >> In-Vehicle Servicing >> Axle Shaft >> Removal

Axle Shaft: Removal

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Remove the 12 differential housing cover bolts and remove the differential cover.
  3. Remove the rear brake disc. For additional information, refer to REAR DISC BRAKE article.
  4. Remove the differential pinion shaft.
    • Remove and discard the differential pinion shaft lock bolt.
    • Remove the differential pinion shaft.
    5. Fig 1: Identifying Differential Pinion Shaft Lock Bolts
    GF0003114Courtesy of FORD MOTOR CO.
  5. Remove the U-washer.
    • Push in on the axle shaft.
    • Remove the U-washer.
    6. Fig 2: Locating U-Washer
    GF0003115Courtesy of FORD MOTOR CO.
  6. Remove the axle shaft.
    7. Fig 3: Locating Axle Shaft
    GF0003116Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals