LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1799 (Rear Drive Axle/Differential - Ford 8.8-Inch Ring Gear -- F150 & Mark LT) >> In-Vehicle Servicing >> Rear Wheel Bearing and Axle Shaft Seal >> Installation

Rear Wheel Bearing and Axle Shaft Seal: Installation

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. If removed, lubricate the new rear wheel bearing with axle lubricant.
  2. If removed, use the special tools to install the rear wheel bearing.
    3. Fig 1: Identifying Special Tools To Rear Wheel Bearing
    GF0003070Courtesy of FORD MOTOR CO.
  3. Lubricate the lip of the new axle shaft oil seal with grease.
  4. Using the special tools, install the new axle shaft oil seal.
    5. Fig 2: Installing The New Axle Shaft Oil Seal
    GF0003071Courtesy of FORD MOTOR CO.
  5. Install the axle shaft. For additional information, refer to Axle Shaft  in this article.
scientia non olet · About LEMON Manuals