Brake Caliper Guide Pins
WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Do not use power tools for caliper guide pin bore cleaning.
The guide pins should slide with a reasonable amount of hand force. If the brake pads show taper wear or the guide pins are difficult to move, then carry out the following steps.
NOTE:
If a guide pin kit is not available, install a new brake caliper assembly.
- Disassemble the guide pins. Refer to FRONT DISC BRAKE article for the front disc brakes or REAR DISC BRAKE article for the rear disc brakes.
- Use a wire brush, rolled-up sandpaper or emery cloth to remove all corrosion and foreign material from the caliper guide pin bores. Clean remaining foreign material from the bores with brake parts cleaner and compressed air.
- Install new brake pads if the lining is not within specifications. Refer to FRONT DISC BRAKE article for the front disc brakes or REAR DISC BRAKE article for the rear disc brakes.
- Assemble the caliper guide pins using new caliper seals, boots and guide pins. Use an ample amount of grease to lubricate the bores and guide pins.