Rear Brake Caliper: Installation
WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
- Position the brake caliper and install the 2 guide pin bolts.
- Tighten to 30 Nm (22 lb-ft).
- Using 2 new copper washers, position the brake hose on the brake caliper and install the flow bolt.
- Tighten to 35 Nm (26 lb-ft).
- Bleed the brake system. For additional information, refer to BRAKE SYSTEM - GENERAL INFORMATION article.