Front Brake Pads: Installation
WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
- Install the new spring clips and brake pads.
- Using a suitable tool, compress the disc brake caliper pistons into the brake caliper bore.
- Position the brake caliper on the brake caliper anchor plate and install the 2 guide pin bolts.
- Tighten to 74 Nm (55 lb-ft).
NOTE:
One brake disc pad kit contains the pads required for both the RH and LH side.
NOTE:
Protect the pistons and boots when compressing the piston into its bore.
NOTE:
Tighten the lower caliper guide pin bolt first.