LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1796 (Front Disc Brake System - F150 & Mark LT) >> Removal And Installation >> Front Brake Caliper >> Installation

Front Brake Caliper: Installation

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using 2 new copper washers, position the brake flexible hose on the brake caliper and install the brake caliper flow bolt.
    • Tighten to 35 Nm (26 lb-ft).
    2. NOTE: Tighten the lower caliper guide pin bolt first.
  2. Position the brake caliper on the brake caliper anchor plate and install the 2 guide pin bolts.
    • Tighten to 74 Nm (55 lb-ft).
  3. Bleed the brake system. For additional information, refer to BRAKE SYSTEM - GENERAL INFORMATION article.
scientia non olet · About LEMON Manuals