P2614 - Camshaft Position Output Circuit / Open
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2007 Ford RV Cutaway, 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Econoline. However, it is still accessible from the selected car via links, so may be relevant.
P2614 - CAMSHAFT POSITION OUTPUT CIRCUIT / OPEN
| Description: | This DTC is set by the powertrain control module (PCM) when no camshaft position output (CMPO) signal is present while the crankshaft position output (CKPO) is active. | |||
| Possible Causes: |
|
|||
| Diagnostic Aids: | Check for the presence of any CMP concerns. | |||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory | |
| All | refer to PINPOINT TEST V . | |||