LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1791 (Engine Controls - Diagnostic Subroutines -- Diesel 6.0L (99P E-Series & 99P F450/550)) >> Diagnostic Trouble Code (DTC) Charts and Descriptions >> P1000 - On-Board Diagnostic (OBD) Systems Readiness Test Not Complete

P1000 - On-Board Diagnostic (OBD) Systems Readiness Test Not Complete

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2007 Ford RV Cutaway, 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Econoline. However, it is still accessible from the selected car via links, so may be relevant.
P1000 - ON-BOARD DIAGNOSTIC (OBD) SYSTEMS READINESS TEST NOT COMPLETE

Description:  The OBD monitors are carried out during the OBD drive cycle. This DTC is stored in continuous memory if any of the OBD monitors do not carry out their full diagnostic check.
Possible Causes: 
  • OBD monitors/drive cycle incomplete
  • Keep alive memory (KAM) cleared
Diagnostic Aids:  The DTC does not need to be cleared from the powertrain control module (PCM) except to pass an inspection/maintenance test.
Application    Key On Engine Off  Key On Engine Running  Continuous Memory 
All   refer to PINPOINT TEST AC .
scientia non olet · About LEMON Manuals