LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1791 (Engine Controls - Diagnostic Subroutines -- Diesel 6.0L (99P E-Series & 99P F450/550)) >> Diagnostic Trouble Code (DTC) Charts and Descriptions >> P0830 - Clutch Pedal Switch A Circuit

P0830 - Clutch Pedal Switch A Circuit

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2007 Ford RV Cutaway, 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Econoline. However, it is still accessible from the selected car via links, so may be relevant.
P0830 - CLUTCH PEDAL SWITCH A CIRCUIT

Description:  The powertrain control module (PCM) monitors the clutch pedal position (CPP) bottom of travel switch only during the calibrated engine speed range (cranking speed range). This DTC is set when the CPP bottom of travel switch does not indicate that the clutch is disengaged (clutch pedal pressed) when the engine is cranked.
Possible Causes: 
  • Damaged CPP top of travel switch
  • Damaged CPP bottom of travel switch harness
  • Open PWRGND circuit to the CPP bottom of travel switch
  • Vehicle push-started with the clutch engaged (clutch pedal released)
  • Aftermarket remote starting device
Diagnostic Aids:  Verify that the vehicle was not push-started with the clutch engaged. Check for aftermarket equipment such as remote starting devices which may bypass the clutch pedal position switch when cranking the engine.
Application    Key On Engine Off  Key On Engine Running  Continuous Memory 
All   refer to PINPOINT TEST C .
scientia non olet · About LEMON Manuals