LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1791 (Engine Controls - Diagnostic Subroutines -- Diesel 6.0L (99P E-Series & 99P F450/550)) >> Diagnostic Trouble Code (DTC) Charts and Descriptions >> P0528 - Fan Speed Sensor Circuit No Signal

P0528 - Fan Speed Sensor Circuit No Signal

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2007 Ford RV Cutaway, 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Econoline. However, it is still accessible from the selected car via links, so may be relevant.
P0528 - FAN SPEED SENSOR CIRCUIT NO SIGNAL

Description:  The powertrain control module (PCM) uses the fan speed sensor (FSS) input to monitor the cooling fan clutch speed. If the indicated fan speed is lower than the calibrated value during the key ON engine running (KOER) self-test, the diagnostic trouble code (DTC) is set.
Possible Causes: 
  • FSS VPWR circuit open in the harness
  • FSS PWRGND circuit open in the harness
  • FSS circuit open in the harness
  • FSS circuit short to voltage or ground in the harness
  • Damaged FSS sensor
  • Damaged PCM
Diagnostic Aids:  Visually inspect the cooling fan clutch for damage or obstruction.
Application    Key On Engine Off  Key On Engine Running  Continuous Memory 
All   refer to PINPOINT TEST AH .
scientia non olet · About LEMON Manuals