LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1790 (Engine Controls - Pinpoint Tests - Diesel 6.0L (99P E-Series & 99P F450/550)) >> PINPOINT TEST AQ: Injection Control Pressure Too Low - Engine Cranking >> Introduction

PINPOINT TEST AQ: Injection Control Pressure Too Low - Engine Cranking: Introduction

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2007 Ford RV Cutaway, 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Econoline. However, it is still accessible from the selected car via links, so may be relevant.

This pinpoint test is intended to diagnose the following:

Fig 1: Injection Control Pressure (ICP) Sensor Connector
GF0001655
Pin Circuit
2 VREF (Reference Voltage)
1 SIGRTN (Signal Return)
3 ICP (Injection Control Pressure)
Fig 2: Powertrain Control Module Connector Terminals
GF0001647
Pin Circuit
E29 ICP (Injection Control Pressure)