LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1789 (Engine Controls - Description And Operation -- Diesel) >> On Board Diagnostics (OBD) Monitors >> Deviations From Standard Gasoline Implementation of OBD

Deviations From Standard Gasoline Implementation of OBD

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2007 Ford RV Cutaway, 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Econoline. However, it is still accessible from the selected car via links, so may be relevant.
  1. Readiness (all monitors complete) is based on diagnostics for the following 6.0L diesel engine systems:
    • CCM
    • misfire detection monitor
    • EGR monitor

    The glow plug monitor is part of the CCM.

    Readiness is based on every OBD (component) having run sufficiently to have found a concern without regard to whether or not a concern exists.

  2. The OBD drive cycle provided in the DIAGNOSTIC METHODS article is used to clear the DTC P1000. The diesel system differs substantially from the gasoline system.
  3. The command to clear DTCs only clears DTC P1000 if all drive cycle testing has been satisfied. All other detected DTCs are cleared with a CLEAR code command from the scan tool if the concern that caused the DTC is no longer present.
scientia non olet · About LEMON Manuals