LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1784 (Engine Controls - Powertrain DTC Charts And Descriptions (Except Diesel & Hybrid)) >> DTC Diagnosis >> P2014 - Intake Manifold Runner Position Sensor/Switch Circuit (Bank 1)

P2014 - Intake Manifold Runner Position Sensor/Switch Circuit (Bank 1)

WARNING: This page does not describe the selected car, but rather 32 other vehicles, including the 2007 Mercury Mountaineer, 2007 Mercury Monterey, 2007 Mercury Montego, 2007 Mercury Milan, and 2007 Mercury Mariner. However, it is still accessible from the selected car via links, so may be relevant.
P2014 - INTAKE MANIFOLD RUNNER POSITION SENSOR/SWITCH CIRCUIT (BANK 1)

Description:  The intake manifold runner control (IMRC) system is monitored for failure during continuous or key on engine off (KOEO) self-test. Each DTC distinguishes the corresponding failed bank for IMRC actuator assemblies with dual monitor switches. The test fails when the signal on the monitor pin is outside an expected calibrated range. This DTC replaces P1516.
Possible Causes: 
  • IMRC monitor circuit open
  • Mechanical concern - bind, seize, damage or obstruction of IMRC hardware
Diagnostic Aids:  Monitor the IMRC and IMRCM PIDs. The IMRCM state should change when the IMRC is commanded open or closed.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All refer to PINPOINT TEST HU .
scientia non olet · About LEMON Manuals