LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1784 (Engine Controls - Powertrain DTC Charts And Descriptions (Except Diesel & Hybrid)) >> DTC Diagnosis >> P1246 - Alternator Load Input

P1246 - Alternator Load Input

WARNING: This page does not describe the selected car, but rather 32 other vehicles, including the 2007 Mercury Mountaineer, 2007 Mercury Monterey, 2007 Mercury Montego, 2007 Mercury Milan, and 2007 Mercury Mariner. However, it is still accessible from the selected car via links, so may be relevant.
P1246 - ALTERNATOR LOAD INPUT

Description:  The powertrain control module (PCM) monitors the generator load from the generator/regulator in the form of frequency. The frequency range is determined by the temperature of the voltage regulator, where 97% indicates a full load, and less than 6% indicates no load.
Possible Causes: 
  • GENLI circuit shorted to voltage or ground
  • GENLI circuit open
  • GENRC circuit shorted to power or ground
  • GENRC circuit open
  • ILC circuit shorted to voltage or ground
  • ILC circuit open
  • Battery-sense circuit open
  • Generator drive mechanism
  • Damaged generator/regulator assembly
  • Damaged PCM
Diagnostic Aids:  Verify the battery voltage is 14.5 volts.
Verify the generator/regulator has the correct part number.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All refer to PINPOINT TEST HY .