LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1784 (Engine Controls - Powertrain DTC Charts And Descriptions (Except Diesel & Hybrid)) >> DTC Diagnosis >> P0704 - Clutch Switch Input Circuit

P0704 - Clutch Switch Input Circuit

WARNING: This page does not describe the selected car, but rather 32 other vehicles, including the 2007 Mercury Mountaineer, 2007 Mercury Monterey, 2007 Mercury Montego, 2007 Mercury Milan, and 2007 Mercury Mariner. However, it is still accessible from the selected car via links, so may be relevant.
P0704 - CLUTCH SWITCH INPUT CIRCUIT

Description:  When the clutch pedal is applied the voltage goes to low. If the powertrain control module (PCM) does not see this change from high to low the DTC is set.
Possible Causes: 
  • Clutch pedal position (CPP) circuit short to voltage
  • Damaged CPP switch
  • CPP circuit open in the SIGRTN
Diagnostic Aids:  When the clutch pedal is applied and then released, the CPP switch voltage should cycle.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All refer to PINPOINT TEST TA . - refer to PINPOINT TEST TA .
scientia non olet · About LEMON Manuals