LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1784 (Engine Controls - Powertrain DTC Charts And Descriptions (Except Diesel & Hybrid)) >> DTC Diagnosis >> P0703 - Brake Switch B Input Circuit

P0703 - Brake Switch B Input Circuit

WARNING: This page does not describe the selected car, but rather 32 other vehicles, including the 2007 Mercury Mountaineer, 2007 Mercury Monterey, 2007 Mercury Montego, 2007 Mercury Milan, and 2007 Mercury Mariner. However, it is still accessible from the selected car via links, so may be relevant.
P0703 - BRAKE SWITCH B INPUT CIRCUIT

Description:  Indicates the powertrain control module (PCM) did not receive a brake pedal position (BPP) input.
Possible Causes: 
  • Open or short in the BPP circuit
  • Open or short in the stoplamp circuits
  • Damage in module(s) connected to the BPP circuit.
  • Damaged brake switch
  • Misadjusted brake switch
Diagnostic Aids:  Check for proper function of the stoplamps. Using a scan tool, check the BPP PID. The stoplamps and PID should toggle on and off with brake pedal activation.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
Freestar/Monterey,
Town Car		 Verify the brake pedal was applied and released during the key on engine running (KOER) self-test. For additional concerns, refer to the appropriate EXTERIOR LIGHTING article.
Expedition,
Navigator		 Verify the brake pedal was applied and released during the key on engine running (KOER) self-test. For additional concerns, refer to the appropriate VEHICLE DYNAMIC SYSTEMS article.
All others refer to PINPOINT TEST FD .
scientia non olet · About LEMON Manuals