Air Conditioning (A/C) Clutch Relay (A/CCR)
WARNING: This page does not describe the selected car, but rather 35 other vehicles, including the 2007 Mercury Mountaineer, 2007 Mercury Monterey, 2007 Mercury Montego, 2007 Mercury Milan, and 2007 Mercury Mariner. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The PCM PIDs WAC and wide open throttle air conditioning cutoff fault (WACF) are used to monitor the A/CCR output.
The A/CCR is wired normally open. There is no direct electrical connection between the A/C switch or electronic automatic temperature control (EATC) module and the A/C clutch. The PCM receives a signal indicating that A/C is requested. For some applications, this message is sent through the communications network. When A/C is requested, the PCM checks other A/C related inputs that are available, such as A/C pressure switch and A/C cycling switch. If these inputs indicate A/C operation is OK, and the engine conditions are OK (coolant temperature, engine RPM, throttle position), the PCM grounds the A/CCR output, closing the relay contacts and sending voltage to the A/CCR.