LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1773 (Roof Opening Panel) >> Removal And Installation >> Roof Opening Panel Shield >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Milan, 2006 Lincoln Zephyr, and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the roof opening panel glass. For additional information, refer to ROOF OPENING PANEL GLASS .
  2. Remove the trough assembly. For additional information, refer to TROUGH ASSEMBLY .
  3. Slide the roof opening panel shield forward halfway.
  4. Disengage the roof opening panel shield guide feet.
    • Lift the front portion of the roof opening panel shield upward at center until able to disengage one of the front guide feet.
      Fig 1: Disengaging Roof Opening Panel Shield Guide Feet
      G04683793Courtesy of FORD MOTOR CO.
  5. With one of the guide feet released, carefully rotate the roof opening panel in a clockwise manner to disengage the remaining guide feet.
    Fig 2: Rotating Roof Opening Panel In Clockwise
    G04683794Courtesy of FORD MOTOR CO.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals