Removal and Installation
WARNING: This page is about a different car, the 2006 Mercury Milan, 2006 Lincoln Zephyr, and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the driver air bag module. For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM .
- Remove the 4 screws and the steering wheel controls bezel.
- Remove the steering wheel controls by pulling the switch toward the rear of the vehicle.
- Disconnect the electrical connector.
- Remove the steering wheel controls bezel, if equipped.
- To install, reverse the removal procedure.
Zephyr
All vehicles