LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1767 (Automatic Transaxle/Transmission - FNR5) >> In-Vehicle Repair >> Transmission Range (TR) Sensor >> Removal

Transmission Range (TR) Sensor: Removal

WARNING: This page is about a different car, the 2006 Mercury Milan and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Disconnect the transmission range (TR) sensor electrical connector and the selector lever cable end.
    Fig 1: Locating Transmission Range (TR) Sensor Electrical Connector And Selector Lever Cable End
    G04681827Courtesy of FORD MOTOR CO.
    3. NOTE: Failure to hold the shift lever, while loosening or tightening the manual shaft lever, will transmit rotational torque to the TR switch and shift mechanism causing internal damage.
  3. Remove the TR sensor (the automatic transaxle is shown removed for clarity).
    1. Remove the nut and the manual control lever.
    2. Remove the bolts and the TR sensor.
      Fig 2: Locating Manual Control Lever Nut And TR Sensor Bolt
      G04681828Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals