LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1767 (Automatic Transaxle/Transmission - FNR5) >> In-Vehicle Repair >> Output Shaft Speed (OSS) Sensor >> Removal

Output Shaft Speed (OSS) Sensor: Removal

WARNING: This page is about a different car, the 2006 Mercury Milan and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Place a drain pan beneath the output shaft speed (OSS) sensor.
  3. Remove the OSS sensor.
    • Disconnect the electrical connector.
    • Remove the bolt.
    • Inspect the OSS bore.
      Fig 1: Identifying OSS Sensor Electrical Connector And Bore
      G04681811Courtesy of FORD MOTOR CO.
  4. Inspect the O-ring seal for nicks or cuts, install a new O-ring if necessary.
    Fig 2: Locating O-Ring Seal
    G04681812Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals