LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1767 (Automatic Transaxle/Transmission - FNR5) >> Diagnosis And Testing >> Diagnosis By Symptom >> Diagnosis by Symptom Chart Directions

Diagnosis by Symptom Chart Directions

WARNING: This page is about a different car, the 2006 Mercury Milan and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using the Symptom Index, select the Concern/Symptom that best describes the condition.
  2. Refer to the routine indicated in the DIAGNOSIS BY SYMPTOM INDEX .
  3. Always begin diagnosis of a symptom with:
    1. Preliminary inspections.
    2. Verifications of condition.
    3. Checking the fluid levels.
    4. NOTE: Not all concerns and conditions with electrical components will set a diagnostic trouble code (DTC). Be aware that the components listed may still be the cause. Verify correct function of these components prior to proceeding to the Hydraulic/Mechanical Routine listed.
  4. Begin with the Electrical Routine, if indicated. Follow the reference or action statements. Always carry out the on-board diagnostic tests as necessary. Never skip steps. If the concern is still present after electrical diagnosis, then proceed to the Hydraulic/Mechanical Routine listed.
  5. The Hydraulic/Mechanical Routines list possible hydraulic or mechanical components that could cause the concern. These components are listed in the removal sequence and by most probable cause. All components listed must be inspected to make sure of correct repair.
scientia non olet · About LEMON Manuals