Removal and Installation
WARNING: This page is about a different car, the 2006 Mercury Milan, 2006 Lincoln Zephyr, and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
- If equipped, remove the 7 screws and the underbody cover.
- Disconnect the exhaust gas recirculation (EGR) tube fitting from the EGR valve.
- To install, tighten to 40 Nm (30 lb-ft).
- Disconnect the exhaust manifold-to-EGR valve tube fitting from the exhaust manifold.
- To install, tighten to 40 Nm (30 lb-ft).
- Remove the exhaust manifold-to-EGR valve tube.
- To install, reverse the removal procedure.