LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1763 (Anti-Theft - Perimeter) >> Diagnosis And Testing >> Anti-Theft - Perimeter >> Inspection and Verification

Inspection and Verification

WARNING: This page is about a different car, the 2006 Mercury Milan, 2006 Lincoln Zephyr, and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify the customer concern.
  2. Visually inspect for obvious signs of mechanical or electrical damage.
    VISUAL INSPECTION CHART

    Mechanical Electrical
    • Hood ajar switch
    • Driver door disarm switch (part of the driver door latch)
    • Luggage compartment anti-theft inhibit switch
    • Circuitry
    • Door latches
    • Driver door module (DDM) (if equipped)
    • Smart junction box (SJB)
  3. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
  4. If the cause is not visually evident, connect the diagnostic tool to the data link connector (DLC) and select the vehicle to be tested from the diagnostic tool menu. If the diagnostic tool does not communicate with the vehicle:
    • Check that the program card is correctly installed.
    • Check the connections to the vehicle.
    • Check the ignition switch position.
  5. If the diagnostic tool still does not communicate with the vehicle, refer to the diagnostic tool operating manual.
  6. Carry out the data link diagnostics test. If the diagnostic tool responds with:
  7. If the DTCs retrieved are related to the concern, go to SMART JUNCTION BOX (SJB) DIAGNOSTIC TROUBLE CODE (DTC) INDEX  or the DRIVER DOOR MODULE (DDM) DIAGNOSTIC TROUBLE CODE (DTC) INDEX .
  8. If DTCs are retrieved that are not found in the following Smart Junction Box (SJB) Diagnostic Trouble Code (DTC) Index or the Driver Door Module (DDM) Diagnostic Trouble Code (DTC) Index, refer to the master Diagnostics Trouble Code (DTC) index in MULTIFUNCTION ELECTRONIC CONTROL MODULES -- FUSION, MILAN, ZEPHYR .
  9. If no DTCs related to the concern are retrieved, GO to SYMPTOM CHART .
SMART JUNCTION BOX (SJB) DIAGNOSTIC TROUBLE CODE (DTC) INDEX

DTC Description Source Action
B1520 Hood Switch Circuit Open SJB GO to PINPOINT TEST C .
B2108 Decklid Disarm Switch Stuck Failure SJB GO to PINPOINT TEST E .
B2116 Driver Door Reset Switch Stuck Failure SJB GO to PINPOINT TEST A .
All Other DTCs - SJB REFER to MULTIFUNCTION ELECTRONIC CONTROL MODULES .
DRIVER DOOR MODULE (DDM) DIAGNOSTIC TROUBLE CODE (DTC) INDEX

DTC Description Source Action
B2116 Driver Door Reset Switch Stuck Failure DDM GO to PINPOINT TEST A .
All Other DTCs - DDM REFER to MULTIFUNCTION ELECTRONIC CONTROL MODULES .