LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1761 (Engine Ignition - 3.0L (4V)) >> Removal And Installation >> Ignition Coil-On-Plug >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Milan, 2006 Lincoln Zephyr, and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

    RH side 

    NOTE: The upper intake manifold must be removed to access the RH ignition coil-on-plugs only.
  1. Remove the upper intake manifold. For additional information, refer to ENGINE - 3.0L (4V) .

    2. Both sides 

  2. Disconnect the 6 ignition coil-on-plug electrical connectors.
    3. NOTE: When removing the ignition coil-on-plugs, a slight twisting motion will break the seal and ease removal.
  3. Remove the 6 bolts and the 6 ignition coil-on-plugs.
    • To install, tighten to 7 Nm (62 lb-in).
  4. To install, reverse the removal procedure.
    • Apply a small amount of dielectric grease to the inside of the ignition coil-on-plug boots before attaching to the spark plugs.
scientia non olet · About LEMON Manuals