LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1757 (Handles, Locks, Latches And Entry Systems) >> Removal And Installation >> Luggage Compartment Lid Lock Cylinder >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Milan, 2006 Lincoln Zephyr, and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the 12 pin-type retainers and the luggage compartment lid trim panel.
  2. Disconnect the luggage compartment lid lock cylinder actuating cable from the luggage compartment lid lock cylinder.
  3. If equipped, disconnect the electrical connector from the luggage compartment anti-theft inhibit switch.
  4. Remove the 2 rivets and the luggage compartment lid lock cylinder.
    • Use the special tool to install new rivets.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals