LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1749 (Exterior Lighting) >> Removal And Installation >> Stoplamp Switch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Milan, 2006 Lincoln Zephyr, and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Do not press the brake pedal when removing or installing the stoplamp switch or damage to the switch will occur.
  1. Disconnect the stoplamp switch electrical connector.
  2. Rotate the stoplamp switch clockwise 45 degrees and remove the stoplamp switch.
    3. NOTE: The stoplamp switch is self-adjusting. Do not press the brake pedal during installation. Initial installation of the stoplamp switch allows for one adjustment. If additional adjustments are necessary, install a new stoplamp switch.
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals