Removal and Installation
WARNING: This page is about a different car, the 2006 Mercury Milan, 2006 Lincoln Zephyr, and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Make sure the headlamp switch and the ignition switch are in the OFF position.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
- Remove the 4 screws and position the fender splash shield aside.
- Release the tabs and remove the fog lamp bezel.
- Release the locking tabs and remove the fog lamp.
- Disconnect the electrical connector.
- To install, reverse the removal procedure.