LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1749 (Exterior Lighting) >> General Procedures >> Front Fog Lamp Adjustment

Front Fog Lamp Adjustment

WARNING: This page is about a different car, the 2006 Mercury Milan, 2006 Lincoln Zephyr, and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Horizontal aim is not required for this vehicle and is not adjustable. Consult your state vehicle inspection center for recommended tolerance ranges for visual aiming.
  1. Before starting the fog lamp assembly adjustment:
    • Check the tire inflation.
    • Make sure there are no other loads in the vehicle other than a half tank of fuel.
    • Make sure the vehicle is on level ground.
    • Make sure the fog lamps and headlamps are clean.
    • Make sure the headlamps are operating and are correctly aimed.
    2. NOTE: The vertical wall screen must be a minimum of 2.4-m (8-ft) wide.
    Fig 1: Identifying Distance Between Vehicle And Vertical Wall Or Screen
    G04682860Courtesy of FORD MOTOR CO.
  2. Park the vehicle on a level surface approximately 7.6 m (25 ft) from the vertical wall or screen directly in front of it.
  3. The correct visual aim for the fog lamps is with the top edge of the high-intensity zone 10 cm (4 in) below the horizontal center of the fog lamps.
    Fig 2: Identifying Correct Visual Aim For Fog Lamps
    G04682861Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals