LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1735 (Manual Transaxle/Transmission) >> In-Vehicle Repair >> Halfshaft Seal >> Installation

Halfshaft Seal: Installation

WARNING: This page is about a different car, the 2006 Mercury Milan and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using the special tool, install the halfshaft oil seal.
    Fig 1: Identifying Special Tools
    G04682104Courtesy of FORD MOTOR CO.
    2. NOTE: Do not allow the splines on the halfshaft to touch the oil seal.
  2. Install the RH intermediate shaft or LH halfshaft. For additional information, refer to FRONT DRIVE HALFSHAFTS .
  3. Fill the transaxle to specification. For additional information, refer to TRANSAXLE DRAINING AND FILLING .
scientia non olet · About LEMON Manuals