LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1729 (Steering Column) >> Removal And Installation >> Steering Wheel >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Milan, 2006 Lincoln Zephyr, and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the steering wheel in the straight-ahead position and turn the ignition switch to the OFF position.
    • Remove the key.
  2. Remove the driver air bag module. For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM .
    3. NOTE: Mark the steering wheel and column shaft for reference during installation.
  3. Remove the steering wheel nut.
    • To install, tighten to 35 Nm (26 lb-ft).
  4. Disconnect the steering wheel switches electrical connector.
    5. CAUTION: Do not remove the steering wheel by hitting the shaft with a hammer. Damage to the column can occur.
  5. Using a suitable puller, remove the steering wheel.
  6. To install, reverse the removal procedure.
    • Align the steering wheel using the reference mark.
scientia non olet · About LEMON Manuals