LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1720 (Engine - 2.3L) >> In-Vehicle Repair >> Engine Oil Pressure (EOP) Switch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Milan and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

    All vehicles 

  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. If equipped, remove the 7 screws and the underbody cover.
    Fig 1: Locating Underbody Cover Screws
    G04680114Courtesy of FORD MOTOR CO.

    3. Vehicles equipped with manual transaxle 

  3. Remove the 2 bolts and position the clutch slave cylinder aside.
    • To install, tighten to 22 Nm (16 lb-ft).

    4. All vehicles 

  4. Disconnect the oil pressure sender electrical connector.
  5. Remove the oil pressure sender.
    • To install, tighten to 15 Nm (11 lb-ft).
  6. To install, reverse the removal procedure.
    • Apply pipe sealant with Teflon® to the oil pressure sender threads.
scientia non olet · About LEMON Manuals