LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1719 (Electronic Engine Controls - 3.0L (4V)) >> Removal And Installation >> Manifold Absolute Pressure (MAP) Sensor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Milan, 2006 Lincoln Zephyr, and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the manifold absolute pressure (MAP) sensor electrical connector.
  2. Remove the bolt and the MAP sensor.
    • To install, tighten to 6 Nm (53 lb-in).
    • When installing the sensor, if the bolt fails to hold specified torque, relocate the sensor and retain, using the auxiliary bolt hole in the intake manifold.
    3. NOTE: Clean and inspect the sealing surface.
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals