LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1718 (Electronic Engine Controls - 2.3L) >> Removal And Installation >> Camshaft Position (CMP) Sensor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Milan and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the camshaft position (CMP) sensor electrical connector.
  2. Remove the bolt and the CMP.
    • To install, tighten to 7 Nm (62 lb-in).
    3. NOTE: Lubricate the CMP O-ring seal with clean engine oil.
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals