LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1710 (Power Steering) >> Removal And Installation >> Power Steering Pump - 3.0L >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Milan, 2006 Lincoln Zephyr, and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: While repairing the power steering system, care should be taken to prevent the entry of contaminants or premature failure of the power steering components can result.
  1. Using a suitable suction device, siphon the power steering fluid from the power steering fluid reservoir.
  2. Remove the accessory drive belt. For additional information, refer to ACCESSORY DRIVE - 3.0L (4V) .
  3. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  4. Release the clamp and disconnect the power steering supply hose from the power steering pump.
  5. Disconnect the power steering pressure switch electrical connector.
    • Detach the electrical harness from the stud on the power steering pump.
  6. Remove the power steering pressure line banjo bolt and disconnect the line from the power steering pump.
    • Discard the bolt and 2 seals.
    • To install, tighten to 48 Nm (35 lb-ft).
  7. Remove the 3 power steering pump bolts and the power steering pump.
    • To install, tighten to 24 Nm (18 lb-ft).
    8. CAUTION: A new bolt and new seals must be installed any time the power steering pressure line is disconnected from the power steering pump or a fluid leak may occur.
  8. To install, reverse the removal procedure.
  9. Fill the power steering system. For additional information, refer to STEERING SYSTEM-GENERAL INFORMATION .
scientia non olet · About LEMON Manuals