LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1708 (Rear Disc Brakes) >> Removal And Installation >> Rear Brake Caliper Anchor Plate >> Removal

Rear Brake Caliper Anchor Plate: Removal

WARNING: This page is about a different car, the 2006 Mercury Milan, 2006 Lincoln Zephyr, and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Disconnect the parking brake cable from the brake caliper.
    • Pull back the parking brake lever.
    • Disconnect the cable from the parking brake lever.
    • Remove the cable conduit retaining clip.
    • Disconnect the cable from the brake caliper.
    3. CAUTION: Do not pry in the caliper sight hole to retract the pistons, as this can damage the pistons and boots.
    CAUTION: Do not allow the brake caliper to hang from the brake hose or damage to the hose can occur.
  3. Remove the 2 brake caliper guide pin bolts and position the caliper aside.
    • Support the caliper using mechanic's wire.
  4. Remove the 2 brake pads, shims and slide clips. Inspect the brake pads for wear or contamination.
    • Inspect the brake pads for wear and contamination.
  5. Remove the 2 brake caliper anchor plate bolts and the anchor plate.
scientia non olet · About LEMON Manuals