LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1708 (Rear Disc Brakes) >> Removal And Installation >> Rear Brake Caliper Anchor Plate >> Installation

Rear Brake Caliper Anchor Plate: Installation

WARNING: This page is about a different car, the 2006 Mercury Milan, 2006 Lincoln Zephyr, and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the brake caliper anchor plate and the 2 brake caliper anchor plate bolts.
    • Tighten to 70 Nm (52 lb-ft).
  2. Install the 2 brake pads and slide clips to the brake caliper anchor plate.
    3. NOTE: Make sure that the brake caliper hose is not twisted.
  3. Position the brake caliper on the anchor plate and install the 2 guide pin bolts.
    • Tighten to 26 Nm (19 lb-ft).
  4. Install the parking brake cable to the brake caliper.
    • Pull back the parking brake lever.
    • Connect the cable to the parking brake lever.
    • Install the cable conduit retaining clip.
  5. Cycle the park brake several times to verify normal operation. For additional information on parking brake adjustment, refer to PARKING BRAKE & ACTUATION .
  6. Test the brakes for normal operation.
scientia non olet · About LEMON Manuals