LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1706 (Noise, Vibration & Harshness) >> General Procedures >> Powertrain/Drivetrain Mount Neutralizing

Powertrain/Drivetrain Mount Neutralizing

WARNING: This page is about a different car, the 2006 Mercury Milan, 2006 Lincoln Zephyr, and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Loosen, but do not remove, the powertrain/drivetrain mount fasteners.
  3. Lower the vehicle.
    4. CAUTION: Do not twist or strain the powertrain/drivetrain mounts.
  4. Move the vehicle in forward and reverse 0.6-1.2 meters (2-4 ft).
  5. Raise and support the vehicle.
  6. Tighten the powertrain/drivetrain mount fasteners.
  7. Lower the vehicle.
  8. Test the system for normal operation.
scientia non olet · About LEMON Manuals