LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1705 (Rear Suspension) >> Removal And Installation >> Wheel Studs >> Installation

Wheel Studs: Installation

WARNING: This page is about a different car, the 2006 Mercury Milan, 2006 Lincoln Zephyr, and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the new wheel stud in the wheel hub, aligning the serrations in the wheel hub flange made by the original wheel stud.
  2. Using a press, install the wheel stud.
    Fig 1: Pressing Wheel Stud
    G04679704Courtesy of FORD MOTOR CO.
  3. Install the wheel bearing and wheel hub assembly. For additional information, refer to WHEEL BEARING AND WHEEL HUB .
scientia non olet · About LEMON Manuals