LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1703 (Exhaust System) >> Removal And Installation >> Exhaust Flexible Pipe >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Milan, 2006 Lincoln Zephyr, and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

    All vehicles 

  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove and discard the 2 exhaust flexible pipe-to-catalytic converter nuts.
    • Discard the gasket.
    • To install, tighten to 40 Nm (30 lb-ft).

    3. 3.0L only 

  3. Remove and discard the 2 RH catalytic converter-to-exhaust flexible pipe nuts.
    • To install, tighten to 40 Nm (30 lb-ft).
  4. Remove and discard the 2 LH catalytic converter-to-exhaust flexible pipe nuts and remove the exhaust flexible pipe.
    • Discard the gasket.
    • To install, tighten to 40 Nm (30 lb-ft).

    5. 2.3L only 

  5. Remove and discard the 2 catalytic converter manifold-to-exhaust flexible pipe nuts and remove the exhaust flexible pipe.
    • Discard the gasket.
    • To install, tighten to 40 Nm (30 lb-ft).

    6. All vehicles 

  6. To install, reverse the removal procedure.
    • Install new gaskets and nuts.
  7. Start the engine and check for exhaust leaks.
scientia non olet · About LEMON Manuals