LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1698 (Anti-Theft System - Perimeter) >> Diagnosis And Testing >> Anti-Theft - Perimeter >> Inspection and Verification

Inspection and Verification

WARNING: This page is about a different car, the 2006 Mercury Montego, 2006 Ford Freestyle, and 2006 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify the customer concern.
  2. Visually inspect for obvious signs of electrical damage.
    VISUAL INSPECTION TABLE

    Electrical
    • Driver door disarm switch
    • Hood switch
    • Horn
    • Door ajar switch(es)
    • Liftgate ajar switch
    • Luggage compartment lid switch
    • Connector(s)
    • Circuitry
    • SJB
  3. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
  4. If the cause is not visually evident, connect the diagnostic tool to the data link connector (DLC) and select the vehicle to be tested from the diagnostic tool menu. If the diagnostic tool does not communicate with the vehicle:
    • check that the program card is correctly installed.
    • check the connections to the vehicle.
    • check the ignition switch position.
  5. If the diagnostic tool still does not communicate with the vehicle, refer to the diagnostic tool operating manual.
  6. Carry out the diagnostic tool data link test. If the diagnostic tool responds with:
  7. If the DTCs retrieved are related to the concern, go to the SMART JUNCTION BOX (SJB) DIAGNOSTIC TROUBLE CODE (DTC) INDEX .
  8. If no DTCs related to the concern are retrieved, GO to SYMPTOM TABLE .
SMART JUNCTION BOX (SJB) DIAGNOSTIC TROUBLE CODE (DTC) INDEX

DTC Description Source Action
B1520 Hood Switch Circuit Open SJB GO to PINPOINT TEST C .
B2116 Door Driver Reset Switch Stuck Failure SJB GO to PINPOINT TEST C .
All other DTCs - SJB REFER to PINPOINT TEST A: NO COMMUNICATION WITH THE SMART JUNCTION BOX (SJB) .