LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1690 (Information System And Entertainment System) >> Removal And Installation >> Antenna Cable >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Montego, 2006 Ford Freestyle, and 2006 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the RH front fender splash shield. For additional information, refer to REMOVAL AND INSTALLATION and REMOVAL AND INSTALLATION .
  3. Disconnect the antenna cable from the antenna base.
    • Push the grommet through the cowl panel.
  4. Remove the A-pillar lower trim panel.
  5. Disconnect the antenna cable connection and remove the antenna cable.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals