LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1681 (Interior Trim And Ornamentation) >> Removal And Installation >> Quarter Trim Panel >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Montego, 2006 Ford Freestyle, and 2006 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the liftgate scuff plate trim panel.
  2. Remove the C-pillar trim panel. For additional information, refer to C-PILLAR TRIM PANEL - FREESTYLE .
  3. Remove the D-pillar trim panel. For additional information, refer to D-PILLAR TRIM PANEL - FREESTYLE .
  4. Position the bottom portion of rear door weatherstrip aside to gain access to rear portion of scuff plate trim panel.
  5. Position the rear portion of the scuff plate trim panel aside to gain access to the rear quarter trim panel retaining screw.
  6. Remove the rear quarter trim panel retaining screw.
  7. Position the 2nd row seats in the flat position.
  8. Position the 3rd row seats in the flat position.
  9. Remove the 3rd row safety belt anchor-to-floor bolt trim cover.
  10. Remove the 3rd row safety belt anchor-to-floor bolt.
    • To install, tighten to 40 N.m (30 lb-ft).
  11. Remove the cargo net retaining hooks.
  12. Position the rear of the rear quarter trim panel away from the body.
  13. Disconnect the auxiliary power electrical connector.
  14. Remove the rear quarter trim panel.
    • Pull the rear quarter trim panel toward the inside of the vehicle to release the retaining clips.
  15. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals