LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1681 (Interior Trim And Ornamentation) >> Removal And Installation >> C-Pillar Trim Panel - Five Hundred, Montego >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Montego, 2006 Ford Freestyle, and 2006 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear seat bolster. For additional information, refer to REMOVAL AND INSTALLATION .
  2. Remove the C-pillar trim panel screw cover.
  3. Remove the C-pillar trim panel screw.
  4. Remove the C-pillar trim panel.
    • Pull the forward bottom edge of the lower C-pillar toward the center of the vehicle.
    • Separate the lower C-pillar from the D-pillar trim panel.
    • Position the C-pillar trim panel toward the inside of the vehicle.
    • Separate the C-pillar trim panel from the rear safety belt.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals