Removal and Installation
WARNING: This page is about a different car, the 2006 Mercury Montego, 2006 Ford Freestyle, and 2006 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
- From under the front of the cushion assembly, push each of the 2 seat cushion floor latch release levers to the left of the vehicle. Lift up at the front and release the front of the cushion assembly.
- Push the cushion assembly back as far as possible. Lift up at the rear outboard ends of the cushion assembly, clearing the retainer hooks from the cushion assembly wire, pull the cushion assembly forward and remove it.
- To install, reverse the removal procedure.
- Make sure the safety belt buckles are accessible to the occupants after installation.